How to Plumb a Bathroom 🚽
1- Determine the location of plumbing fixtures in the bathroom.
- The location of your bath or shower, sink and toilet will have to be worked out. This will decide where the plumbing lines will need to run.
- You'll need to cut holes in the floor so you can run the pipes to the fixtures, so it's important to determine the exact placement.
- Locate and mark both cut points and drill points carefully Check again to ensure accuracy of your markings.
- "Twice check, cut once" may be an old saw, but there are still teeth.
- Do all the necessary cutting and drilling. Until switching off the shower, you want to do the planning work to reduce your "clean" period.
2- Turn the water off at the home.
3- Install the lines of water.
4- Connect the lines of drain.
5- Set up the toilet.
6- Set up the shower.
7- Hook up a shower and tub unit.
https://plumberirvingtexas.com/
469-909-0161 📞
#Emergency_plumbing
#Plumbing_contractors
#bathroom_faucets
#plumbing_services
#plumbing_tools
#emergency_plumber
#plumber
#Licensed_plumber
#emergency_plumber
#24_hr_plumbing
#toilet_installation
#Plumbing_Irving_TX
#Plumbing_In_Irving_TX
#Toilet_Repair_Irving_TX
#Toilet_Repair_In_Irving_TX
No comments:
Post a Comment